Xerox 480 ST - Manual (Page 31)

Xerox Document Centre System Administration Guide Page 3 - 3
3.
Dy
nami
c/
St
at
ic
IP
Addr
es
se
s and
WI
NS
3
. Dyn
a
mic
/S
ta
ti
c
IP
Ad
dre
ss
e
s and WIN
S
Go to the dynamic server and...
1. Configure the DHCP, BOOTP, or RARP server with the
TCP/IP information you want assigned to your printer. Use
the documentation supplied with your server software for
this task.
Go to the Document Centre and...
2. Connect your Document Centre to the network with the
appropriate cabling.
3. Enter the Tools pathway
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current password. Press
the Enter button when finished. The Touch Screen will
be used for the remainder of the data entry, unless
instructed otherwise.
c) Press the Go to Tools button.
4. Enter the Network Setup menus.
a) Wait for the screen to refresh and press the Connectivity
and Network Setup button.
b) Wait for the screen to refresh and press the Network
Setup button.
c) Press the TCP/IP Options button.
5. Enable TCP/IP printing.
a) Press the TCP/IP Settings button.
b) Press the Protocol and Media button.
c) Press the Enable button. If Physical Media buttons
appear, select either Ethernet or Token Ring. Press
Save.