Xerox 480 ST - Manual (Page 74)

Page 9 - 6 Xerox Document Centre System Administration Guide
Go to the workstation and...
NOTE This procedure assumes that any TCP/IP components necessary for
network installation have already been assigned to the Document
Centre. If these components have not been configured, please refer
to the appropriate information contained within the section entitled
Dynamic/Static IP Addresses & WINS before continuing further.
1. Verify that the TCP/IP protocol stack is loaded.
2. Use the CentreWare Network Services CD-ROM to install
print drivers. Details for this are found in the document sup-
plied with your printer entitled CentreWare Network Ser-
vices Guide.
Windows 95/98, Windows NT 4.X Workstation and
Windows 2000 Users
• Add a network printer as you normally would.
• Browse for and Double-click the name of the WorkGroup for
the printer as shown on the Configuration Report.
• Double-click the NetBIOS Host Name of the printer as shown
on the Configuration Report.
• Click once on the Printer Name as shown on the Configura-
tion Report then click OK.
• For a new printer you will be prompted for a print driver.
Select Have Disk and browse to the directory with the Docu-
ment Centre driver, select it then click OK.
3. Open an application and print a test page to verify operation.
4. If your print job does not print, refer to the Troubleshooting
section of this document to solve the problem.
5. Check your test job for quality and use the Problem Solving
section of the Document Centre Reference Guide for
resolving print defects.
6. Repeat this Go to the workstation and... procedure for each
workstation on the network that will print to the printer.