Edimax Technology PS-3103P - Manual (Page 47)

5.2 NetWare 3.x Installation & Setup
Once your PrintSir is connected to your Ethernet
network, you can set it up for use with your networking
software. There are two methods you can use to do this
easily:
Please note that, you need install the IPX protocol
before the following procedure,
1. On DOS environment or DOS box of Windows, use the
“INSTALL” quick-installation program found on the
<CD-ROM Drive>\DOSUTIL of CD-ROM included with
the PrintSir.
2. On DOS environment or DOS box of Windows, use the
“PSETUP” configuration program found on the included
<CD-ROM Drive>\DOSUTIL, configure the PrintSir to
use a particular file server. Then, use NetWare’s
PCONSOLE program to create a NetWare print server
and print queue with the appropriate names.
5.2.1 Quick Installation Using “Install” program
The INSTALL program included on the CD-ROM can
be used to quickly set up the PrintSir for use on the
NetWare environment. It can only be used to set up the
PrintSir as Printer Server mode; it cannot be used to
configure the PrintSir as Remote Printer mode. It handles
changing the PrintSir’s internal settings, the creation of
NetWare print server and print queue objects on the file
server, and the assignment of the print server to the queue.
Unless you need to configure the NetWare settings to
conform to special requirements for your network, you can
use the quick installation method.
47