Dhcp, Bootp – Edimax Technology PS-3103P User Manual
Page 72
ping <IP Address>
For example, a PrintSir with the following
configuration:
Node ID: 0000B4010101
(the Node ID is printed on the rear side
of the PrintSir)
Assign IP address: 203.66.191.12
arp
–s 203.66.191.12 00-00-B4-01-01-01
ping 203.66.191.12
At the mean time, PrintSir’s IP will “temporarily”
be set to 203.66.191.12 (will restore after reboot).
Therefore, you need to run your web browser to set a
permanent IP address (refer to section 8.3.7 for detailed
IP configuration).
6.3.2 DHCP
There are many Unix systems that support DHCP
protocol, and the procedures to configure the DHCP
server database are different. This manual does not
describe the DHCP server configuration on the Unix
systems. It is highly recommended that the DHCP
server should be located on the same network as the
PrintSir.
6.3.3 BOOTP
If you have the BOOTP daemon, bootpd, running
on your UNIX system that is accessible by the PrintSir,
you can use the BOOTP protocol to set up the IP
address of the PrintSir. We recommend that the BOOTP
72