Edimax Technology PS-3103P - Manual (Page 71)

6.2 Enable PrintSir’s TCP/IP Support
The default configuration of the PrintSir is with
TCP/IP support enabled. Anyway, you can configure the
PrintSir to enable TCP/IP support using the configuration
program or PSETUP program in the CD-ROM included
with the PrintSir.
6.3 Setup PrintSir’s IP Address
The PrintSir must have a unique IP address in order to
be recognized by the network.
You can set up the IP address on the various Unix
systems using any one of the following methods:
1. ARP & Ping Assignment (Recommend for Unix)
2. DHCP (Dynamic Host Configuration Protocol)
3. BOOTP (Bootstrap Protocol)
4. RARP (Reverse Address Resolution Protocol)
The PrintSir will use the last three methods to obtain
its IP address automatically if its IP address is configured
as Auto (0.0.0.0).
6.3.1 ARP & Ping Assignment
You can use ARP and Ping commands with a web
browser to complete PrintSir’s IP address setting.
Parameters for the commands are as follows:
arp –s <IP Address> <Ethernet ID>
71