Edimax Technology 3G-6200nL V2 - Manual (Page 83)

82
Item Name Description
WAN Fail Over Check this box to enable the fail over function.
WAN Priority Please select the WAN link priority from the drop-down menu.
Idle Timeout
Detect Please input the amount of time for the Internet connection
to idle before the router sends a ping to the target IP address.
Ping Target IP Please input the target IP address.
When you are finished with the settings in this page, you can click ‘Apply’ button to
save changes you made in this page, or you can click ‘Cancel’ to discard changes. After you
click ‘Apply’ button, you’ll see the following messages:
Please click ‘Apply’ to save changes you made and restart the broadband router, this
requires about 30 seconds and the broadband router will stop responding (this is normal
and is not malfunction). You can reconnect to this broadband router and continue on other
settings later.
3-5-6 3G Limit Control
The “3G Limit Control” function allows you to set a limit to the amount of 3G data you
use. When the “3G Limit Control” function is enabled and the amount of 3G data
transmission exceeds the limit you have set, the router will stop accessing the Internet via
the 3G USB modem.
The “3G Limit Control” function measures the amount of 3G data transmission in
months. For example, if you select “19”, the “Cumulative 3G Data” value will reset on the
19
th
of every month. The “Cumulative 3G Data” value will also reset if you power off the
device or if the network has been disconnected.