Edimax Technology BR-6624 - Manual (Page 16)

2. Installing The Load Balancer in your LAN
Figure 2-4: Installation Diagram
1. Ensure The Load Balancer and the DSL/Cable modem are powered OFF.
Leave the modem or modems connected to their data line.
2. Connect the Broadband modem or modems to The Load Balancer.
• If using only one (1) Broadband modem, connect it to the "WAN 1" port.
• Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
3. Use standard LAN cables to connect PCs to the Switching Hub ports on The Load Balancer.
• Both 10BaseT and 100BaseT connections can be used simultaneously.
• If you need to connect The Load Balancer to another Hub, just use a standard LAN cable to
connect any port on The Load Balancer to a standard port on another hub. Any LAN port on
The Load Balancer will automatically act as an "Uplink" port when required.
4. Power Up
• Power on the Cable or DSL modem or modems.
• Connect the supplied power adapter to The Load Balancer and power up.
5. Check the LEDs
• The
Power LED should be ON.
• The
WAN – Link LED should be ON, if the corresponding WAN port is connected to a
broadband modem.
• The
Error LED will flash during start up, but will then turn Off. If it stays On, there is an error
condition.
Page 12