Vitek VT-1510 SR - Manual (Page 6)

6
ENGLISH
• Set the required temperature for mak-
ing coffee by pressing the (18) button,
the (24) indications will appear on the
display (6). One indication corresponds
to the low temperature; three indications
correspond to the maximal temperature
(24).
• Depending on the coffee using type, put
coffee in pods in the filter holder (3) or
put ground coffee using the measuring
spoon (33), slightly tamp ground cof-
fee against the sealer (4). Heat the filter
holder (3) before using, by placing it on
the cup support base (7).
• Set the filter holder (3) on its place and
turn it to the right until bumping (pic.3).
• Put one or two heated cups according to
the coffee using variant under the filter
holder, and press coffee making button
(16). After you have made coffee, two
sound signals will be heard (pic.4).
• After you have made coffee, remove the
filter holder (3), by turning it to the left
(pic.3). Remove the remaining coffee
(pic.8) and wash the filter holder (3) un-
der tapping water.
Note: at the end of coffee making proc-
ess you will hear sound of outputting
steam, it is normal.
- Check water tray filling indication (13),
when it appears in the hole of the grid
(2), remove the grid (2) from the tray (1),
remove the tray (1) from the base and
pour out water from the tray (1), set the
tray (1) on its place, set the grid (2) on
the tray (1).
Individual programming
You can program two modes of preparing
coffee on your own taste taking into ac-
count temperature mode, making one or
two cups of coffee simultaneously, using
grinded coffee or coffee in pods, and also
depending on volume of coffee to be made.
In order to save modes of preparation, it is
necessary to make coffee one time:
- Switch coffee machine on using button
(14).
- Depending on the type of used coffee,
put coffee in pods or grinded coffee into
filter holder (3) using measuring spoon
(33), ram grinded coffee down a little to
the sealer (4).
- Set filter holder (3) to its place and turn it
to right up to stop (picture 3).
- Put one or two cups under filter holder
(3) depending on preset type of making
coffee (picture 4).
Programming
• Press button (17) and select mode P1 or
P2. Selected function will be indicated on
display (6) by symbol (28).
• Press and hold buttons (15) and (18) si-
multaneously for 3 seconds. Symbol P1
or P2 (28) will be blinking on display (6).
• Select one or two cups of coffee (sym-
bols (27) and (30) on display) using but-
ton (15).
• Press and hold for 3 seconds button (15),
select variant of using coffee in pods or
grinded coffee (symbols (21) and (22) on
display (6)).
• Select temperature mode for making cof-
fee by pressing button (18). Temperature
values are displayed as symbols (24) on
display (6). One symbol indicates low
temperature; three symbols indicate
maximal temperature (24).
• Press and hold button (16). When you get
necessary amount of coffee, release the
button (16).
• After symbols P1 or P2 (28) stop blinking
on display (6), the modes will be memo-
rized.
• Switch coffee machine off by pressing
button (14), remove filter holder (3) by
rotating it to the left (picture 3). Remove
coffee remnants (picture 8) and wash the
holder under water jet.
1510.indd 6 1510.indd 6 02.04.2008 15:43:59 02.04.2008 15:43:59