Vitek VT-1510 SR - Manual (Page 7)

7
ENGLISH
Using programmed operating modes
- Switch coffee machine on using button
(14).
- Depending on the type of used coffee,
put coffee in pods or grinded coffee into
filter holder (3) using measuring spoon
(33), ram grinded coffee down a little to
the sealer (4)
- Set filter holder (3) to its place and turn it
to right up to the stop (picture 3).
- Put one or two cups under filter holder
(3) depending on the preset type of mak-
ing coffee (picture 4).
- Select one or preprogrammed operating
modes (P1 or P2) using button (17).
- Press button (16).
- On completion of work, witch coffee ma-
chine off by pressing button (14), detach
filter holder (3) by rotating it to the left
(picture 3). Remove coffee remnants
(picture 8) and wash the holder under
water jet.
Preparing “Cappuccino”
You can whip up creams or milk for mak-
ing “cappuccino” coffee or warm up other
beverages by hot steam using this coffee
machine.
• Fill reservoir (9) with cold water up to
«МАХ» mark (pictures 1, 2).
• Make sure steam supply is locked by ro-
tating handle (10) clockwise up to stop.
• Switch coffee machine on using button
(14).
• Select steam supply mode by pressing
button (19), at that symbol (31) and rotat-
ing symbol (29) is flashed, when steam
supply temperature is reached, rotating
symbol (20) will be deemed.
• Put appropriate container for collecting
water under cappuccinator-pipe (12)
and slightly turn steam supply handle
(10) anticlockwise to release condensate
(picture 6). Drain condensate out of the
container.
• Pour about 100 ml of milk or creams into
appropriate container (mind that either
container, milk or creams should be very
well cooled).
• Put container with milk or creams under
cappuccinator-pipe (12) and open steam
supply by rotating steam supply handle
(10) anticlockwise up to stop (picture 7).
• After required amount of foam is reached,
rotate steam supply regulator handle (10)
clockwise up to stop.
• In order to avoid obstruction of cappucci-
nator-pipe (12), put appropriate contain-
er with some water inside under the pipe
(12) and open steam supply for several
seconds by turning steam supply handle
(10) anticlockwise up to stop, afterwards
lock steam supply by turning handle (1)
clockwise up to stop.
Attention! Be aware of burns by hot
steam.
Notice: During the process of steam
generation, flips or clicks are heard.
These flips appearance is result of peri-
odical turning the pump on, this is nor-
mal.
Boiling water
You can warm some water for making tea
using this coffee machine.
• Fill reservoir (9) with cold water up to
«МАХ» mark (pictures 1, 2).
• Make sure steam supply is locked by ro-
tating handle (10) clockwise up to stop.
• Switch coffee machine on using button
(14).
• Select hot water supply mode by press-
ing button (19) and select symbol (32) on
the display (6).
• Put appropriate container for collecting
water under cappuccinator-pipe (12)
and turn steam supply handle (10) anti-
clockwise up to stop (picture 6).
• After necessary amount of water is
poured into the container, turn off water
supply by turning team supply handle
(10) clockwise up to stop.
1510.indd 7 1510.indd 7 02.04.2008 15:43:59 02.04.2008 15:43:59