Philips HR1858 - Manual (Page 7)

- Only unlock the clamps after you have switched off the appliance and the filter has stopped
rotating.
- Do not operate the juicer for more than 40 seconds at a time when juicing heavy loads and let
it cool down sufficiently afterwards. None of the recipes in this user manual constitute heavy
loads.
- Do not remove the pulp container when the appliance is operating.
- Always unplug the appliance after use.
electromagnetic fields (eMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Preparing for use
1 Wash all detachable parts (see chapter ‘Cleaning’).
2 Put the plug in the wall socket.
3 Place the juice collector into the appliance (1). Place the pulp container by tilting it forwards
slightly (2). Insert the top end of the pulp container first and then push home the bottom
end (Fig. 2).
To empty the pulp container while you are juicing, switch off the appliance and carefully remove the
pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4 Put the filter in the juice collector (1). Hold the lid over the filter and lower it into position
(2). (Fig. 3)
Make sure the filter is fitted securely onto the driving shaft (‘click’).
Always check the filter before use. If you detect any cracks or damage, do not use the appliance
and contact the nearest Philips service centre or take the appliance to your dealer.
5 Snap the two clamps onto the lid to lock it into place (‘click’) (1). Align the groove in the
pusher with the small protrusion on the inside of the feeding tube and slide the pusher into
the feeding tube (2) (Fig. 2).
Make sure the clamps are locked into position on either side of the lid.
6 Place the juice jug under the spout (Fig. 4).
Place the lid on the juice jug to avoid splattering or if you want to store the juice in the refrigerator.
using the appliance
The appliance only functions if all parts are properly assembled and the lid is properly locked in
place with the clamps.
1 Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding
tube. (Fig. 5)
2 Make sure the juice jug is placed under the spout.
3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the
appliance. (Fig. 6)
- Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers and raspberries.
- speed 2 is suitable for all kinds of fruits and vegetables.
EnglisH 7