Accusys ExaSAN B08S2-PS - Manual (Page 56)

4. How to Use
User Guide Page 4-5
4.1.2.1 Adding and Removing Controllers
In order to administer a controller, it first needs to be added to the network. Once added, the administrator
is given full control over the controller.
RAIDGuard X is a powerful GUI management system. It can be used for remotely monitoring the RAID
controller. If using the server to administer RAID configurations, you must make sure that the RAID host
and server are on the same network. The direct attached storage client can also add or remove controllers
in RAIDGuard X.
Adding
1. Click Add Controller to display a list of available controllers on the network. If the ExaSAN RAID
system is used as a DAS, the controller is displayed as “Local” under the IP field.
2. Click on the controller to administer, enter the password. The default password for the Accusys PCIe
controllers is 00000000 (8 zeros).
3. Assign a name to the controller and click Add.
Figure 36: GUI “Add RAID controller”
4. The Main screen lists the controller after it has been successfully added.
Note
To change the controller password, refer to Section 4.1.2.7.3 MISC.