Acroprint TQ600 (software version 4.x and above) - Manual (Page 26)

20
5) Press [OK], the following screen is displayed:
6) Press [OK]. Press [ESC] to exit user enrollment or press [OK] to
continue changing passwords.
User Verification Types
Fingerprint Verification
There are (3) fingerprint verification (“authentication”) types:
1:1 Verification (“One to One” Verification)
In this mode, a user enters their 5-digit User ID and takes a fingerprint
reading. The TQ600 compares their fingerprint to the fingerprint
template of the User ID that was entered, thus a 1:1 comparison. The
1:1 verification method is the fastest verification method since it only
has to compare the user’s fingerprint to one template stored in the
terminal.
1) In the initial interface, enter your ID number and the following
appears:
Note: The User ID is 5 digits. If you enter a number with less
than 5 digits the TQ600 adds 0’s in order to create a 5 digit
User ID, i.e., if you enter “11” the TQ600 will Enroll “00011”.
1:1 FP Match
User ID 00011
ESC OK
Chg Password
00001-P
ESC OK (Save)
Note: 00006-P
“-P” means password
enrollment