Acroprint TQ600 (software version 4.x and above) - Manual (Page 44)

38
„ Sleep: Set a time the terminal will go into sleep mode. Pressing
any button will awaken the terminal.
„ Idle: Select “SLP” or “OFF” for the Idle mode. “SLP” – Sleep
mode allows the terminal to be awakened by pressing any key.
“OFF” - Turns the unit off and the power button must be pressed to
turn the unit on.
„ Idle Min: Set how many minutes of no use before the terminal
goes into the selected “Idle” mode. Setting “Idle Min” to “0” turns
off this feature.
„ Bell Delay: Set the length of time the bell sounds. A setting of 5
sets the bell to ring for 10 seconds. A setting of 10 sets the bell to
ring for 20 seconds.
„ Scheduled Bell: There are 20 bell schedules. Enter the times
you would like the bell to sound. The bell will sound at the
scheduled times for the duration set in the “Bell Delay”.
„ Lock Power: If set to “Y” the terminal cannot be turned off using
the power button. To turn the unit off with the power button
locked, enter the “Power Mng” menu and scroll down to “Power
Off”.
Communication Options
Select “Comm Opt”, press [OK], the following appears:
Comm. Opt ▼
►Baud Rate 115200
Dev Num 1
IP Addr
----------------------------
Net Speed AUTO
NetMask
Gateway
Ethernet Y
RS232 N
RS485 N
USB Y
COMM Key 0