Acroprint TQ600 (software version 4.x and above) - Manual (Page 45)

39
The TQ600 Biometric and TQ600 Proximity fully support Ethernet,
RS232 & USB communications. TQ600 Barcode and TQ600 Magnetic
Stripe support Ethernet and direct connection to PC (cable not included).
„ Baud Rate: The baud rate may be set to 9600, 19200 38400,
57600 & 115200.
„ Dev Num: The terminal’s unique Device Number, the range is 1 to
255.
„ IP Addr: Defaults to IP address 192.168.1.201
„ Net Speed: The default Net Speed is “AUTO”, the other options
are 10M-F, 10M-H, 100M-F and 100M-H.
„ NetMask: The default Net Mask is 255.255.255.0
„ Gateway: The default gateway is 0.0.0.0
„ Ethernet: Turn Ethernet connectivity on or off.
„ RS232: Turn RS232 connectivity on or off.
„ RS485: Not Supported
„ USB: Turn USB connectivity on or off. Note: This is a serial
connection established via USB cable.
„ COMM Key: Not utilized
Note: After setting, restart the terminal for the new
configurations to take effect.
Log Options
Select “Log Opt”, press [OK], the following message appears:
Log Opt
►Alm SuperLog 99
Alm AttLog 99
ReCheck Min 0