Acroprint TQ600 (software version 4.x and above) - Manual (Page 42)

36
Press [▲/▼] to scroll up or down to select the option.
„ Reset Opts.: Restore all setup values to factory defaults.
„ Delete AttLogs: Delete all transaction logs.
„ Clear All Data: Delete all users and logs. (Note: You will
lose all information stored on the terminal.)
„ Clr Admin Pri: Change all privilege levels to User.
„ Voice On? Turn voice prompts on or off.
„ Show Score: Show the degree to which a fingerprint reading
matches the stored template. 0 is the lowest score (no match) and
50 is the highest score (perfect match).
„ Match Thr: Set the fingerprint match threshold level. The
threshold value can be set 0 – 75 (default is 35). See Table 1-1.
„ Mst Input ID: Turns 1:1 (one to one) fingerprint verification on
or off.
„ 1:1 Thr: The minimum fingerprint read correlation needed to
achieve a positive match for 1:1 verification.
„ Voice: Set the voice prompts on or off.
„ Upd Firmware: The user cannot update the firmware
unless this feature has been enabled by the manufacturer
or an authorized dealer.
„ Work Code: Enables/disables the work code feature on the clock.
If enabled, 4 Modes are available. Mode 1 and Mode 2 are not
supported. Use Mode 3 if you have timeQplus software and want
to use global list of work codes per company. Mode 4 allows to use
individually assigned work codes for employees (see timeQplus
Software).
„ Button Beep: Turn audible feedback on/off when pressing
buttons on the keypad.
„ Adj VOL(%): Adjust the volume level (0-99); “0” turns off the
speaker.