Acroprint TQ600 (software version 4.x and above) - Manual (Page 28)

22
1) Place finger on the sensor surface, the following appears:
2) It continues for about 0.5 seconds. If the test is successful, the
following appears:
3) If your identity cannot be verified, you are prompted to try again,
the following appears:
It continues for about 0.5 seconds, return to the start-up window.
Password Verification
A password 1 to 5 digits long is used to validate authentication.
Password verification can be used in special cases, i.e., when all of a
user’s fingerprints are damaged. This method of verification does not
provide the security of biometric identification and should only be used
when absolutely necessary. Note: when a user with an enrolled
password attempts (1:1) verification the TQ600 will ask for the User’s
password and the user will not have the option of taking a fingerprint
reading.
Verify
User ID 00001
Verified.
FP Verify
Remove Finger
FP Verify
Please Try Agn.