Installation and setup – AASTRA BluStar 8000i User Guide EN User Manual
Page 10
Installation and Setup
5
41-001389-00 Rev 02 – 04.2012
Installation and Setup
The following procedure provides instructions for setting up the BluStar 8000i terminal, and for connecting it to your net-
work.
1.
Carefully remove the BluStar 8000i components from their shipping container and place them on a clean, flat, dry
surface (typically a desktop).
2.
Connect one end of the handset cable to the RJ-11 connector on the end of the handset, and the other end to the RJ-
11 connector on the underside of the terminal.
Note:
You can tuck the cord into the indent at the side of the terminal.
3.
Connect the Ethernet cable (provided with the BluStar) into the network LAN port marked with
. Contact your
network system administrator for help with this connection.
4.
Plug the other end of the Ethernet cable directly into the jack on the wall.