AASTRA DT390 for MX-ONE User Guide EN - Manual (Page 103)

C ORDLESS P HONE FOR MX-ONE™
103 1424-EN/LZT 103 087 Uen F2 2012-03-02
18 Troubleshooting
This chapter contains information on how to solve common operational
problems, see table 12 on page 103, and warnings, see table 13 on page
103, you may receive. Go through the following lists if you encounter any
problems. If the checklists do not solve the problem, contact the system
administrator. If others have similar problems, there may be a system
error.
Table 12 Operational problems
Table 13 Error or warning messages
Fault Probable cause Action or comment
No display The battery level is
low or the phone is
defective. Charge the battery.
No ringing 1. The mute icon
is shown in the
display
2. The ring volume
set to silent
3.. The phone is
defective.
1. Make a long press
on ,
2. Increase
volume(settings>Sou
nd & Alerts>Volume
3. Send the phone for
service.
Signal strength icon
off Out of system
coverage area or the
phone is defective. Enter coverage area.
Call is switched off
after 2 seconds The phone is
defective. Contact the system
administrator.
Display shows Probable cause Action or comment
Enter PIN The phone’s lock is
activated. Enter the required
PIN code. If you have
lost the PIN code,
configure a new or do
a factory reset in
WinPDM.
No access The network is in
range, but no access
rights. Switch off the phone
and then switch it on
again.