AASTRA 630d for Aastra 400 User Guide EN - Manual (Page 63)

Supplementary features
eud-1292/1.0 – R1.0 – 01.2011
63
The remote control is initiated using a special */# procedure. You can then enter the
function commands and */# procedures.
<Setting value> Using remote control from a third-party phone:
1. Enter procedure #36.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the */# procedure for activating/deactivating the function you want.
Press the Call key.
➔
Acknowledgement tone sounds; function is activated/deactivated.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter
"Changing the User PIN" , page 78 or use */#
procedure *47 (see "User’s Guide */# Procedures" on the Aastra document
portal:
www.aastra.com/docfinder ). If you have forgotten your PIN, your system
administrator can reset it to the default setting.