AASTRA 630d for Aastra 400 User Guide EN - Manual (Page 68)

Personalizing your phone
68
eud-1292/1.0 – R1.0 – 01.2011
Activating range alarm and system busy beep
You want to set the system parameters with your cordless phone.
The Range alarm indicates that the connection between your phone and the system is
weak. You can set the phone so that you receive a warning signal if you leave the cov-
erage area
• You are making a call and are getting near the limit of the radio area: A warning sig-
nal sounds in the loudspeaker and the LED indicator is flashing red. If you leave the
radio area, the call is disconnected.
• The phone is in standby mode and you leave the radio area (only for phones on an
alarm system, see chapter "Alarm" , page 89 ): The phone warns you by means of a
continuous ringing. After acknowledging this continuous ringing, it will be again
triggered after approx. one minute.
The System busy beep tells you that the system is overloaded – you need to wait until
the system is available again.
Press the navigation key to the right or the Menu softkey.
Settings
Scroll to Settings and press the Select softkey.
General
Scroll to General and press the Select softkey.
<Setting>
Select the setting you want and switch on or off with the Select softkey.