None key, Configuring a none key, Line keys, programmable keys, and softkeys – AASTRA 6755i User Guide EN User Manual
Page 121
Line Keys, Programmable Keys, and Softkeys
41-001386-00 REV01 – 06.2013
114
None Key
You can set a softkey, programmable key, or expansion module key to force a blank entry on the IP phone display for a spe-
cific key. You do this by setting the key to "None". The keys are added in order (from key1 to key20) after any hard-coded
keys have been added. If a particular key is not defined, it is ignored. For more information about key behavior, see
on
.
Configuring a None Key
Use the following procedure to configure a None key on the 6755i IP Phone. The procedure shows the softkey screen as an
example.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.
Aastra Web UI
1.
Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Click on Operation->Expansion Module <N>.
Softkeys
2.
Select from "Key 1" through "Key 20".
3.
In the "Type" field, select None.
Programmable Keys
4.
Select from "Key 1" through "Key 6".
5.
In the "Type" field, select None.
Expansion Module Keys
6.
Select from “Key 1” through “Key 36” (M670i).
or
Select from “Key 1” through “Key 60” (M675i).
7.
In the "Type" field, select None.
8.
Click Save Settings.