AASTRA 6755i User Guide EN - Manual (Page 122)

Line Keys, Programmable Keys, and Softkeys
115
41-001386-00 REV01 – 06.2013
Empty Key
You can set a softkey to force a blank entry on the IP phone display for a specific key. You do this by setting the softkey to
"empty". The keys are added in order (from key 1 to key 20) after any hard-coded keys have been added. If a particular
key is not defined, it is ignored.
Configuring an Empty Key
Use the following procedure to configure an Empty softkey on the 6755i phone.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Click on Operation->Expansion Module <N>.
Softkeys
2. Select from "Key 1" through "Key 20".
3. In the "Type" field, select Empty.
4. In the state fields, check (enable) or uncheck (disable) the states you want to apply to this softkey.
Programmable Keys
5. Select from "Key 1" through "Key 6".
6. In the "Type" field, select Empty.
Expansion Module Keys
7. Select from “Key 1” through “Key 36” (M670i).
or
Select from “Key 1” through “Key 60” (M675i).
8. In the "Type" field, select Empty.
9. Click Save Settings.