AASTRA 6755i User Guide EN - Manual (Page 97)

Line Keys, Programmable Keys, and Softkeys
41-001386-00 REV01 – 06.2013
90
Flash Key
You can set a key to generate a flash event when it is pressed on the 6755i. You do this by setting the key to "flash". The IP
phone generates flash events only when a call is connected and there is an active RTP stream (for example, when the call is
not on hold).
Configuring a Flash Key
Use the following procedure to configure a Flash key on the 6755i IP Phone. The procedure shows the softkey screen as an
example.
Sprecode Key
You can set a key to automatically activate specific services offered by the server by setting a key to "Sprecode". For exam-
ple, if the sprecode value of *82 is configured, then by pressing the key, *82 automatically activates a service provided by
the server. The value you enter for this field is dependent on the services provided by the server. Contact your System
Administrator for information about available services.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Click on Operation->Expansion Module <N>.
Softkeys
2. Select from "Key 1" through "Key 20".
3. In the "Type" field, select "Flash".
4. In the "Label" field, enter a label to display on the phone for the key.
Programmable Keys
5. Select from "Key 1" through "Key 6".
6. In the "Type" field, select "Flash".
Expansion Module Keys
7. Select from “Key 1” through “Key 36” (M670i).
or
Select from “Key 1” through “Key 60” (M675i).
8. In the "Type" field, select "Flash".
9. (M675i) In the "Label" field, enter a label to display on the phone for the key.
10. Click Save Settings.