Delay, Output gpis settings – EVS IPDirector Version 5.6 - May 2009 Part 1 User's Manual User Manual
Page 78
IPDirector Version 5.6 – User Manual – Part 1: General Workspace
EVS Broadcast Equipment - – May 2009
Issue 5.6.D
67
Delay
It is possible to specify a delay between the time the GPI key is pressed and the
time the action will be carried out on the XT[2] server.
O
UTPUT
GPI
S
S
ETTINGS
The Output GPIs are signals that are sent by the GPI from an XT[2] server under
the control of the IPDirector.
The Output GPIs settings are used to send a signal from the IPDirector to a GPI
key at a given timecode of a playlist played on a given player channel. This signal
can then be used to trigger a record action of the playlist from the given timecode
by a third device, for example a VTR. Up to eight Output GPI commands can be
defined.
The Output GPI keys will be unavailable in IPDirector if they have been assigned
to the Remote panel via the Replace function defined on the Remote panel itself.
For each Output GPI, the output mode, the pulse duration and the offset value can
be set when defining the Output GPI. Refer to the following sections in the Playlist