See next page for parts list – Hotchkis 2253 Sway Bars, Set, 65-66 GM B-Body, Sport User Manual
Page 10
10)
Unbolt the bracket from the end link. Hold the bracket back up in position to the bolts hanging
from the frame. Use the nylock nuts included to hold the bracket on the bolts. Tighten the
hardware holding the bracket to the frame. Torque the nuts to 80 ft/lbs.
11)
Re-attach the end links to the brackets and tighten the hardware into place. Torque the end link
hardware to 80 ft/lbs.
12)
Check that all hardware is tight. Use the caps provided to cover the zerk fittings and you’re done
installing the Hotchkis rear sway bar!
IMPORTANT:
For maintenance, use the zerk fittings to grease the bushings at least once a year
(15,000 miles) or when excessive noise occurs. Use a non-lithium based grease only! A lithium-based
grease can wash out with water and should not be used.
SEE NEXT PAGE FOR PARTS LIST