Hotchkis 2268 Hardware pack for 59-64 Rear Sway Bar User Manual
Page 4
4
7)
With the bar supported on the passenger side you can now slide the power steering bracket
over the driver’s side end of the bar. The bracket should slide over the bar and line up with the
stock mounting holes and the welded stud in the frame.
Tighten the hardware on the inside edge of the bracket nearest to the hole that the bar passes through.
Route the power steering lines over the sway bar!
8)
Take the second bushing (already greased in step 6) and place it over the driver’s side with the
sway bar retainer bracket. For cars without power steering
(photo on the left) the bracket will
mount to the holes in the same manner as the passenger side of the vehicle.
The driver’s side bracket mounts inside of the power steering bracket included with the Hotchkis kit.
Slide the retainer bracket into place over the bolts and tighten the bracket into place.