Hotchkis 2290 SSR Sway Bar Set - Manual (Page 4)

11) Install the provided polyurethane bushings onto the bar. Try to install the
bushing so that the split is facing the front of the vehicle. Remember to
lube the inside hole with the provided grease.
12)
With the polyurethane bushings in place, you can secure the new Hotchkis
cradle brackets over the bushings. Before you reinstall the bolts to the
frame, it’s a good idea to apply some anti-seize to the bolt threads. Fully
tighten the subframe bolts.
13)
Finally, attach the end links to the control arms. Fully tighten the nuts.
14) Support the front of the vehicle with your jack and remove your jack
stands. Lower the jack and you’re finished.
You’re done with the front stabilizer bar installation! Let’s move on to the rear installation.