Hotchkis 22110F Sway Bars, Front, 10-11 Camaro, Competition - Manual (Page 7)

4R Reinstall the Hotchkis Sway Bar
Reinstall the Hotchkis Sway Bar in the same manner as stock removal. Your kit comes with new bushings and
brackets. Apply the provided silicone grease in the inside area of each bushing. Install the bushings onto the bar.
When reinstalling the stock bushing bracket nuts, please use the provided washers from your hardware kit. You
should use one washer for each bolt totaling 4 for the rear installation. Apply a small amount of lock threading
compound (included in your kit) on each bolt. Make sure to use the brackets that have the straight grease fitting
attached. Fully tighten the bracket hardware.
5R Reinstall the End Links
Insert the end links back into the sway bar ends and fully tighten the nuts using the supplied lock threading
compound.
6R
Final Inspection
Before lowering the rear end back onto the ground, make sure all hardware is fully tightened. You are finished with
the Rear Hotchkis Sway Bar installation. Enjoy your new Sway Bar set.