Hotchkis 2260 1968-1974 Nova Sport Sway Bar Set - Manual (Page 5)

13) Remove the triangle brackets from the end links. Attach the brackets to the stud plate
with the large end of the bracket closest to the ground. Tighten the hardware holding
the bracket in place.
14) Re-attach the end links to the brackets, and tighten all attaching hardware on the end
links.
WARNING
: Check the end link clearance to the bracket hardware. If the hardware contacts the
end link it can wear a hole though the end link as the bar rotates in use. You will not be able to
install the bar if the stud plate makes contact with the end link.
15) Check that all attaching hardware is tight. Use the caps provided to cover the zerk fittings
on the end links. Lower the car and re-install the rear seats. You’re done installing the
Hotchkis rear sway bar! Use a good, non-lithium based, chassis grease to maintain
bushing lubrication.
2207