Hotchkis 2260R 1968-1974 Nova Rear Sport Sway Bar User Manual
Page 4
10)
Use the Anti-Seize provided in hardware kit #T1722 to apply a small amount on the u-bolt
threads. This will prevent damage to the nylock nuts when tightening or possible damage to the
u-bolts. With the bar centered on the axle tighten the u-bolt hardware to 35-40 ft-lbs.
11)
Rotate the sway bar into place with the triangle brackets up against the body. Use a scribe or
other marking tool to mark the locations of the holes on the body matching the bracket. Drill out
two 1/2" diameter holes on each side to match the bracket locations
.
12)
Drop the stud plate in from the passenger compartment through the holes. Place one of the
large washers provided over the lower stud on the plate. This will act as a shim. It is also
suggested to apply a ring of silicone gasket sealer to the edges of the holes and the stud plate
to act as a water sealant.