Hotchkis 2260R 1968-1974 Nova Rear Sport Sway Bar User Manual
Page 5
13)
Remove the triangle brackets from the end links. Attach the brackets to the stud plate with the
large end of the bracket closest to the ground. Tighten the hardware holding the bracket in
place. Torque the nuts to 30 ft/lbs.
14)
Re-attach the end links to the brackets, and tighten all attaching hardware on the end links.
Torque the end link hardware to 35 ft/lbs
WARNING
: Check the end link clearance to the bracket hardware. If the hardware contacts the end link
it can wear a hole though the end link as the bar pivots during use. You will not be able to install the bar
if the stud plate makes contact with the end link.
15)
Check that all attaching hardware is tight. Use the caps provided to cover the zerk fittings on the
end links. Use a jack to remove the jack stands and lower the car.