Hotchkis 22412 04-07 Scion xA-xB Sport Sway Bars - Manual (Page 2)

7) Once these bolts are all out, the subframe should only be held on by the lower control
arms.
8) Carefully pull down on the back part of the
subframe, giving you access to the rear
anti-sway bar.
9) Take the factory endlink and remove the
nuts that hold it all together using 14mm
wrenches
10) Use a 12mm socket to remove the two
bolts holding each stabilizer bar bracket
11) Carefully pull the passenger side arm of the sway bar over the steering arms, then pulls
the bar out by carefully twisting the bar over the steering hoses.
12) Please note the location of the factory
bushings on the stock setup. You are
going to install the new polyurethane
bushings in the same location.
13) Install the new Hotchkis bar in the
reverse manner that you used on the
stock bar.
14)
Carefully spread an even layer of
grease on the inside of the Hotchkis
bushings and install onto the bar. Pay
attention to the direction the split is