MSD 2960 Atomic LS7 Master Kit Installation - Manual (Page 3)

INSTALLATION INSTRUCTIONS 3
M S D
• W W W . A T O M I C E F I . C O M • ( 9 1 5 ) 8 5 5 - 7 1 2 3 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
FUEL RAIL FUEL RAIL
COVER
LIFT THIS SIDE OF
COVER ENOUGH TO
CLEAR FUEL RAIL
FUEL RAIL FUEL RAIL
COVER
PUSH COVER
FUEL RAIL FUEL RAIL
COVER
LIFT COVER UP
DISENGAGE
FROM FUEL
RAIL
Figure 1
Figure 2
Figure 3
Figure 4
PREPARING THE FUEL RAILS FOR IN-
STALLATION
1. Lift the rounded end of the rail cover off of the fuel
rail (Figure 1).
2. Lubricate the o-rings on the injectors with some
motor oil or silicone lubricant. Install the injector
retainer clips onto the injectors. The injector clips
will automatically secure the injector to the fuel rail
when they are inserted into the bung (Figure 2).
3. Install the clips onto the injector before they are
pushed into the fuel rail bung. The injector clip will
automatically secure the injector to the rail.
4. Lubricate the o-rings on the injectors with some
motor oil or silicone lubricant and push the fuel
injectors into the bung without forcing them on. The
injectors should slide in easily. Use the injector clips
to lock the injectors onto the fuel rails (Figure 2).
WARNING: Forcing the injectors into the bung can
damage the o-rings, which can cause an engine fire.
5. Plug the fuel injector pigtails into the fuel rail
connections (Figure 3).
6. Connect the fuel injector pigtails to the injectors. The
long wires connect to the injectors on each end of
the fuel rail. The short wires connect to two inner
injectors (Figure 4).