MSD 2960 Atomic LS7 Master Kit Installation User Manual

Page 4

Advertising
background image

4

INSTALLATION INSTRUCTIONS

M S D

•   W W W . M S D P E R F O R M A N C E . C O M   •   ( 9 1 5 )   8 5 5 - 7 1 2 3   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4

7. Plug the FPS connector into the fuel pressure sensor under

the fuel rail (Figure 5).

8. Connect the CAN cable from one rail to the other (Figure

6).

9. Connect the heavy red Rail Power wires together between

the two rails (Figure 7).

FUEL RAIL INSTALLATION

1. Preassemble the rail brackets with a washer and the M6 x

100MM bolts on the angled end. Use a single 6mm x 16mm

hex head bolt on the closed end of the flange. Coat the ends

of the 100mm bolts with thread sealant (Figure 8).

2. Place the spacer/bushing/rail bracket assemblies onto the

intake manifold. The angled end of the bracket is always

facing to the left when installed correctly on either side of

the engine. The rear passenger bracket will require a spacer

between the intake manifold and the bracket (Figure 9)

Figure 5

Figure 6

Figure 8

Figure 7

Figure 9

SPACER

Advertising