3 zero operation, 4 changing weighing units, 5 check-weighing/counting, percent check – Ohaus EB COMPACT SCALES Manual multi User Manual
Page 13
EB SERIES EN-7
4.3 Zero Operation
Center of Zero s ndcated by “
ZERO” on the dsplay.
Press
ZERO. “------” wll be dsplayed momentarly before the
dsplay s zeroed.
4.4 Changing Weighing Units
Press
UNITS successvely to toggle through the avalable
weghng unts.
Compares the weght or quantty (count) of an tem aganst a pre-
set H-Lo range.
To ntate enterng H-Lo parameters, press
CHECK. “00000.0”
wll be dsplayed (or the last value entered) wth the actve dgt
flashng.
Enter the desred “H” lmt value (ex. 50g) by pressng or
to navgate across the dgts, and to ncrement the actve
dgt. Press
Enter
to set the dsplayed value.
“00000.0” wll be subsequently dsplayed (or the last value
entered). Enter the desred “Lo” lmt value (ex. 20g), then
press
Enter
to set the dsplayed value.
When the weght or quantty of tems placed on the pan s wthn
the H-Lo range,
“OK“ s dsplayed and the check-alarm wll beep contnuously
wthn ths range.
To check-count, press
CHECK n Countng Mode (dsplayed unt
s “pcs”)
For Percent check, press
CHECK n Percent Mode (dsplayed
unt s “%”)
4.5 Check-Weighing/Counting, Percent Check