Ohaus EB COMPACT SCALES Manual multi - Manual (Page 14)

EN-8 EB SERIES
NOTES:
• If only a H value was set (Lo value s “0”), the check-alarm wll actvate
and dsplay “OK” above ths value. If only a Lo value was set (H value s
“0”), the check-alarm wll actvate and dsplay “OK” below ths value.
• Weght must be more than 20 scale dvsons for Check-Weghng/Countng
to operate.
• H-Lo values are retaned when the unt s turned off.
• Separate H-Lo values for check-weghng and countng (pcs) may be
entered.
• To clear the H-Lo values, press Clear then Enter as the values are
dsplayed. Ths effectvely exts from Check-Weghng/Countng Mode also.
4.6 Sampling, Calculating Average Piece Weight (APW)
Countng Mode s ndcated by “ pcs” or “pc” on the dsplay.
Place the desred sample onto the weghng pan (or nto a
tared contaner) (ex. 500g).
Press COUNT to ntate samplng. “SP 10” (or last sample
szed used) wll be dsplayed, then press Enter. “------“ wll be
dsplayed momentarly before the sample sze pece count s
dsplayed.
NOTES:
• To change the sample sze, press successvely to dsplay: “SP 20”,
“SP 50”, “SP 100”, “SP 200”, “SP 500”, “SP 1000”. Press Enter to select
the dsplayed sample sze.
• APW values are not retaned when the unt s turned off.
• To ext from Countng Mode and clear the APW, press COUNT.