Chapter 3 start to use nvr, 1 connect to nvr, Chapter 3 – QNAP Security NVR-101 (Version: 2.8.0) User Manual
Page 28: Start to use nvr, Connect to nvr
Chapter 3
Start to Use NVR
When you have installed NVR and other hardware, and connected it to the network,
you can use the browser in your PC to connect to NVR. It is recommended to use
Microsoft Internet Explorer 6.0 for browsing.
Important Notice:
Before you start to use NVR, you must install a hard disk or two in NVR, finish disk
volume configuration and format the hard disk(s). Otherwise, the system may not
function properly. Please refer to Chapter 5.4.1 for disk volume configuration
details.
3.1 Connect to NVR
Follow the steps below to connect to NVR monitoring page:
1. Open an IE browser and enter the IP address of NVR. Or execute the Finder
shortcut on the Desktop. When the following screen is shown, double click the
name of NVR.
Double click NVR
name to login the
server
28