VTech CS6649_-2-3 Manual - Manual (Page 32)

28
Multiple handset use
Intercom
To initiate an intercom call at the telephone base:
Press INT on the telephone base when not in use.
If you have only one handset, the telephone base
shows Calling HS 1. The handset rings and shows
Base is calling.
If you have two or more handsets, the telephone base
shows Intercom to. Use the dialing keys to enter a
handset number. The telephone base shows
Calling HS X. The destination handset rings and shows
Base is calling.
To answer the intercom call on the destination handset,
press , INT, or any dialing key (0-9, TONE or
QUIET
#
). Both devices now show Intercom.
To end the intercom call at the telephone base, press INT, or
/SPEAKER when using the base speakerphone, or place the
corded handset back to the telephone base. Both screens display
Intercom ended.
-OR-
To end the intercom call on the destination handset, press
OFF, or place the handset back in the handset charger.
Both screens display Intercom ended.
If you do not have any cordless handset registered to the
telephone base, you will hear two beeps when you press INT on the base.
You can cancel the intercom call before it is answered by pressing CANCEL or INT.
If the destination handset is not powered, out of range, on a call, or does not answer
the intercom call within 100 seconds, your telephone base displays Unable to call
and then returns to idle mode.
•
•
•
1.
•
•
2.
3.
Intercom to
Base is calling
ECO
10:01 AM 11/20
Intercom
MSG #
1