Appendix, Add and register a handset, Expand your telephone system – VTech CS6649_-2-3 Manual User Manual

Page 61

Advertising
background image

Appendix

57

The cordless handsets provided with your telephone system are already registered as

HANDSET 1 and so forth. Additional handsets registered to the telephone system are

assigned numbers in the sequential order. This telephone system accommodates up

to five handsets.
You can add new handsets (

CS6609, purchased separately) to your telephone

system. Each handset must be registered with the telephone base before use. When

first purchased and properly charged, each expansion handset displays

To register HS and See manual alternately. You may need to charge the handset

before registering it to the telephone base. For more information on battery charging,

see the table on page 4.

Add and register a handset

When first purchased, each expansion handset alternately shows

To register HS and See manual. The new handset should

be charged without interruption for at least 30 minutes before

registering it to the telephone base.
Make sure the handset is out of the handset charger and is put

near the telephone base. Make sure the handset alternately

shows

To register HS and See manual before you begin

registration.

To register a handset:

Press and hold

FIND HANDSET on the telephone base for

about four seconds until the

IN USE light turns on and it

shows

Registering...

Press

QUIET

#

on the handset. The handset shows

Registering... Both the telephone base and cordless handset

show

Registered, and you hear a beep from the handset

when the registration process completes. The registration

process takes about 60 seconds.

If registration fails, the handset displays

Failed. Try again the

registration process above.

You cannot register a handset if any other system handset is

in use.
If you have not set the date and time for the telephone system,

the handset will prompt you to set the date and time after it is

registered to the base. To skip setting, press

CANCEL.

You can only register one handset to the telephone base at a time.

1.

2.

Expand your telephone system

Appendix

Before registration,

make sure the handset

is not in the charger.

Advertising