Velleman DVR4MQAE - Manual (Page 28)

DVR4MQAE - 28 - VELLEMAN
DEVICE
Press the “ ” button to enter the system setting page.
1.
Select the desired channel of the installed external
device. Press “Edit” to enter the setting box.
2. Device Type:
Choose either general camera or PTZ camera.
3. ID No.:
Choose the ID number (from 0 to 255) of the installed
external PTZ device.
4. Protocol Type:
Choose “NORMAL” protocol for our own brand
camera.
Choose “P-D” (PELCO-D) protocol for all VELLEMAN
cameras.
5. Baud Rate:
Set the baud rate of each channel (2400, 4800, 9600,
19200, 38400, 57600, 115200), depending on the
specifications of the dome camera.
6. After setting, press “OK” and then press “APPLY” to
confirm.
DETECTION
Press the “ ” button to enter the system setting
page.
1.
Select the desired channel and press “Edit” to enter
the motion detection sensitivity and area setting
box.
2. Motion Detection Sensitivity:
Set the detection sensitivity in 4 different adjustable
factors.
LS: The sensitivity of comparing two different
images. The smaller the value, the higher sensitivity
for motion detection.
SS: The sensitivity towards the size of the triggered
object on the screen (the number of motion
detection grids). The smaller the value, the higher
sensitivity for motion detection.
TS: The sensitivity towards how long the object gets
triggered. The smaller the value, the higher
sensitivity for motion detection.
RE: The value of RE is a reference for detection.
The bigger the value, the higher sensitivity for
motion detection.
3. Alarm:
Select LOW / HIGH for the alarm polarity.
4. Motion Detection Area:
Clicking the area with the mouse and choose the
motion area to be detected. The detection area is a transparent picture while the undetected area is in pink
colour.