Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake with CBC-SmartLock '04-07 - Manual (Page 20)

20
97055 v.8.0
10.
Locate two spring band clamps
and slide over the rubber hose that
were routed down to the left side of
the transmission in step 1.
11.
Locate the blue hose, this hose
will connect to the vacuum solenoid in
Section 4, and insert the hose in the
rear 90-degree barb fitting. Secure the
hose to the fitting by sliding the spring
band clamp into place. See Figure 18.
12.
Locate the black hose, this hose
will be the vent line for the boost
actuator, and insert the hose in the
front 90-degree barb fitting. Secure the
hose to the fitting by sliding the spring
band clamp into place. See Figure 18.
13.
Secure the two rubber hose
away from any heat source or moving
components with zip ties up to the left
side of the engine compartment.
14.
Lower the vehicle.
15.
From the top of the engine
compartment locate the black hose
that will serve as the vent line for the
boost actuator. Secure the hose to the
wiring harness on the rear rail on the
driver side using a zip tie.
16.
Locate the breather assembly and
a spring band clamp. Slide the spring
band clamp over the vent line hose.
Insert the breather assembly into the
hose. Secure the breather assembly
to the hose by sliding the spring band
clamp into place. See Figure 19.
17.
The blue hose will be connected
to the vacuum solenoid in the next
section. Route the hose along the
rail to the right side of the engine
compartment over the Banks Brake.
-END OF SECTION 3-
Figure 17