Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake with CBC-SmartLock '04-07 - Manual (Page 36)

36
97055 v.8.0
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
NoteS: Before drilling, confirm that
there is adequate room for the Brake
enable and overdrive Disable Switches
and wires behind the dash. Make sure
wires or obstructions are cleared from
the drilling area.
Make sure there is enough wire on
the Banks Wiring Harness to reach the
Switch from where the Brake enable
and overdrive Disable Switches will be
located.
Late 2004 thru 2005 Switch
install
The Banks Brake Enable and Overdrive
Disable Switches can be installed in
one of two places. Location #1, on
the drivers side of the instrument
panel (IP) next to the steering column
(Figure 40) or location #2, on the
knee panel above the brake release
(Figure 41).
Location #1
1.
Remove the headlamp switch
bezel on the driver’s side by gently
pulling on it. Disconnect the electrical
connector once the bezel is removed.
2.
Remove the center bezel, open
the ashtray and cup holder and
remove the retaining screw. Gently
pull on the center bezel to disengage
all the clips that attach the bezel
to the dash. Disconnect the four
(4) electrical connections after the
bezel is removed. Keep the screw for
reinstallation.
Figure 40 Location #1- Late 2004 thru 2005 models
Section 7
Brake Enable and Overdrive Disable Switch Installation.