Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake with CBC-SmartLock '04-07 - Manual (Page 34)

34
97055 v.8.0
CAUTION: Pull gently to avoid
damage to the Wiring Harness
Connectors or wires. Always pull
on the Wiring Harness housing
rather than the wires themselves.
Trucks with a Banks Diesel Tuner
skip to Note at end of step 16.
15.
Locate the Banks OBD II Interface
Cable in your kit. Connect the red OBD
II Male Connector on the Banks OBD
II Interface Cable to the vehicle’s OBD
II female connector. Slide a cable tie
through the metal frame above the
factory OBD II female connector and
secure the Banks Interface Cable to
the vehicle’s OBD II connector (Figure
38).
16.
Connect the 8-pin Connector on
the Banks OBD II Interface Cable to the
8-pin OBD II Interface Connector on
the Cab Cable (Figure 39).
Note: If a Banks Six-Gun or an
ottoMind Diesel tuner has been
installed in your vehicle, disconnect
the oBD II 8-pin Connector from the
tuner Harness and connect to the
CBC/SmartLock’s oBD II Interface
Connector. take the oBD II Connector
from the Diesel tuner and connect it
to the Cab Cable’s tuner Connector.
Refer to Figure 39 for a close up.
-eND SeCtIoN 6-
Figure 38 oBD II Interface Cable