Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake with CBC-SmartLock '04-07 - Manual (Page 30)

30
97055 v.8.0
4.
Attach the Ground wire (Black
wire with ring terminal) to an existing
bolt by removing the existing bolt and
sliding the ring terminal over the bolt.
Re-install the bolt. Use Figure 31 as
an example location on the driver’s
side fender.
Note: Make sure your ground
location is clean from dirt, grease and
corrosion or the Banks CBC/SmartLock
may not function properly.
5.
The Banks CBC/SmartLock will
be installed on top of the fuse box
cover in the engine compartment.
Clean the top surface of the fuse box
and the bottom side of the Banks
CBC/SmartLock and ensure that the
surfaces are clean and free of oil,
grease, and dirt. Clean and dry as
required using a cloth dampened with
rubbing alcohol or similar cleaning
solution.
CAUTION: Do not spray fluid
directly onto/into any electrical
equipment or damage to the
equipment may result.
6.
With the supplied Velcro strips,
peel the protective backing off of
the adhesive tape and apply it to
the backside of the CBC/SmartLock.
Peel the other side of the protective
backing off. Install the CBC/SmartLock
onto the fuse cover as shown in
Figure 32. Hold the module against
the fuse box cover for approximately
1 minute while applying pressure to
allow the tape to properly adhere to
the surface.
oPtIoNAL: there is a Bracket kit
available separately from Gale Banks
engineering (kit #55298) that will make
your installation look cleaner if a Banks
Six-Gun or an ottoMind Diesel tuner
has been installed in your vehicle. Use
a torx t-10 tool to remove the end
cover screws from the ends of the
tuner and the CBC/SmartLock. Use the
supplied Brackets to connect the CBC/
SmartLock to the tuner (Figure 33).
7.
Locate the CBC/SmartLock
Connector on the Banks Wiring
Harness and plug it into the CBC/
SmartLock module.
Figure 33 optional Bracket P/N 55299 Shown