Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch - Manual (Page 20)

20
96808 v.14 .0
6.
Remove the OBD II interface cable
from the vehicle.
Installing Banks Brake Wire
Harness
7.
From inside the engine
compartment, locate the factory
brake pressure sensor connector on
the brake master cylinder. The brake
pressure sensor will be the connector
farthest away from the firewall. See
Figure 16. Disconnect the factory
brake pressure sensor connector.
8.
Locate the Brake Pressure Sensor
harness in your kit. connect the
female connector on the Brake
Pressure Sensor harness to the factory
male connector. connect the male
connector on the Brake Pressure
Sensor harness to the factory female
connector.
9.
Route the 2-pin connector on
the Brake Pressure Sensor harness
following the Six-Gun/EconoMind
in-cab cable through the fire wall.
Secure the wiring harness with the
supplied cable ties away from any heat
source or moving parts.
10.
From under the dash, pull the
2-pin connector on the Brake Pressure
Sensor harness through the fire wall.
11.
Locate the Banks Brake Wire
Harness and connect the 2-pin male
connector on the Brake Pressure
Sensor harness to the 2-pin connector
on the Banks Brake wire harness.
12.
connect the Banks Brake Wire
Harness OBD II connector to the
vehicle’s OBD II connector. Use a cable
tie, as shown in Figure 17 to secure
the Banks Brake Wire Harness to the
vehicle’s OBD II connector.
13.
Locate the Fuse connector on the
Banks Brake Wire Harness and connect
it to the mini-fuse blade tap location
#22. Replace the fuse cover and make
sure not to pinch the Fuse wire.
14.
Now, connect the 8-pin connector
from the Banks Brake Wire Harness to
the 8-pin connector on the Six-Gun/
EconoMind In-cab cable.
15.
Locate the Foot Brake position
switch connector under the dash.
See Figure 18. Disconnect the foot
brake position switch connector.
Figure 16 Brake Pressure Sensor