Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch - Manual (Page 22)

22
96808 v.14 .0
Figure 19 Remove column panel covers
16.
Locate the Brake Position
Switch intercept connectors on the
Banks Brake Wire Harness. connect
the female connector on the Brake
Position Switch intercept connectors
to the factory black brake position
switch connector. connect the male
connector on the Brake Position Switch
intercept connectors to the factory
female brake position connector that
was disconnected.
17.
From under the steering column,
remove the three (3) screws that hold
the steering column panel covers in
place. See Figure 19.
18.
Using a standard screw driver
remove the plastic ignition key guide.
See Figure 20.
19.
Move the steering column down
to the lowest possible position to aid
in removal of the top steering column
panel. Remove the top steering column
panel.
CAUTION: Be careful when
removing the top steering column
panel or damage may result.
20.
Locate the tow haul connector
under the main wire harness towards
the top rear of the steering column.
See Figure 21.
21.
Disconnect the tow haul
connector.
22.
Locate the tow haul intercept
connector on the Banks Brake Wire
harness. Route the Tow Haul intercept
connectors under the dash towards
the front of the vehicle and up to the
top of the steering column following
the factory harness to the factory
tow haul connector. Make sure the
connectors and wires are free of
rotation from the steering column.
connect the female connector on
the Tow Haul intercept connectors to
the factory male tow haul connector.
connect the male connector on the
Tow Haul intercept connectors to the
factory female tow haul connector.
Secure the connectors and wires with
supplied cable ties.