Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch - Manual (Page 26)

26
96808 v.14 .0
9.
All Model Years: If only installing
the Six-Gun/EconoMind, only drill
the hole closest to the driver side
window to ease installation. Using a
13 ⁄
32
” Uni-drill, center the bit onto the
13 ⁄
32
” drill location(s) on the template
and slowly drill through. Using a 1 ⁄
8
”
drill bit, center and drill through the
1 ⁄
8
” location on the template. Remove
and discard the template and any
plastic shavings. De-burr the drilled
hole(s) as needed to ensure that the
Six-Gun/EconoMind/Brake selector
switch(s) fit(s) squarely against the
dash panel.
10.
Remove the nut and internal
tooth washer(s) from the Six-Gun/
EconoMind/Brake switch and test fit
the switch(s) into the drilled hole(s).
Ensure that the alignment pin(s)
properly fit(s) in the 1 ⁄
8
” hole. Enlarge
the holes as necessary to allow the
switch to properly fit. Do not fasten
the switch to the dash panel yet.
11.
Align the Banks Six-Gun/
EconoMind/Brake label on the
previously drilled hole(s) on the front of
the dash panel. Make sure the entire
mounting surface is clean and free
of dirt and oil before mounting the
label. clean and dry as required using
a cloth damped with rubbing alcohol
of similar cleaning solution. Remove
the adhesive backing and affix the
label to the dash panel. Hold the label
against the panel for approximately
20 seconds while applying pressure to
allow the adhesive to properly adhere
to the surface.
12.
Rotate the switch
counterclockwise until the shaft stops.
Verify that the Six-Gun/EconoMind
washer tab is inserted into the #6
position on the switch and that the
Banks Brake washer tab is inserted
into the #5 position on the switch as
shown in Figure 27. Note: All of the
power settings may not be usable
if the tabs are not inserted into the
proper position.
13.
Install the switch(s) through the
13 ⁄
32
” hole(s) on the backside(s) of the
bezel. The alignment pin(s) should rest
in the 1 ⁄
8
” hole(s) and the switch(s)
Figure 24: Template taped to back of dash on 2003-04 model year vehicle, ready
to be drilled.
2003-04 model year vehicles only