Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch User Manual
Page 39
96808 v.14.0
39
Section 10
REMOVAL OF THE SIx-GUN/ECONOMIND DIESEL TUNER
If the Six-Gun/EconoMind Diesel Tuner
should ever need to be removed from
the vehicle, perform the following:
NoTE: The ignition must remain in the
oFF position throughout the removal
process.
1.
Disconnect the Six-Gun/
EconoMind’s 46-pin connector
(connector c) from the middle
connection on the PcM.
2.
Re-connect the vehicle’s 46-pin
connector back into the middle
connection on the PcM.
3.
Disconnect the Six-Gun/
EconoMind’s MAP connections
from the vehicles MAP sensor and
harness. Re-connect the vehicle’s MAP
connector back into the MAP sensor.
4.
Disconnect the 2-ring terminals
from the EGT thermocouple.
5.
Disconnect the 3 small connectors
on the ‘In-cab cable’ and gently pull
the cable back through the firewall.
6.
Remove the Six-Gun/EconoMind
Diesel Tuner.
Failure to follow the above instructions
when removing the module will result
in a “check Engine” light on the dash
and a Diagnostic Trouble code being
stored in the factory computer, in
addition to the engine not running.
Note: Banks Brake will not function
without the Six-Gun/econoMind
tuner installed.
-END, SEcTION 10-
table 2: Banks Brake Fault Codes