Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch User Manual

Page 25

Advertising
background image

96808 v.14.0

25

Caution: Do not use excessive

force when working on plastic

parts. Permanent damage to the

part might result
For 2003-04 model year vehicles,

follow the selector switch installation

procedure Step 1. For 2005-07 model

year vehicles, skip to Step 7.

1.

Remove the lower driver side

interior panel that allows access to the

fuse box.

2.

Remove the stereo using Ford

stereo removal tools as shown in

Figure 23. These are readily available

at automotive supply stores.

3.

Remove two (2) bolts that reside

above the stereo. These are accessible

once the stereo has been removed.

4.

Detach the dash. At this point

the dash is held in place entirely by

removable fasteners. Disconnect all

electrical connections on the back of

the dash once it has been detached.

5.

Remove the dash from the vehicle.

6.

cut out the template in Figure 36

on page 41 and tape to the backside

of the dash panel as shown in Figure

24 for 2003-04 model year. The

template will be used as a guide for

drilling the holes to locate the Six- Gun

selector switch.

For 2003-04 model year vehicles,

skip to Step 9 to finish the selector

switch(s) installation procedure.

7.

2005-07 Automatic Transmission

vehicles: Set the vehicle’s parking

brake. Insert the key and turn the

vehicle to the ‘ON’ position without

starting it. Pull the shift lever down

into first gear to allow clearance for

dash panel removal.
All 2005-07 vehicles: Pull the plastic

trim surrounding the instrument panel

and radio / climate controls towards

you until it releases from the main

dashboard — it is attached by a series

of spring clips around its perimeter.

Disconnect all electrical connectors

from the back of the dash trim and

remove it from the vehicle.

8.

cut out the template in Figure 36

on page 41 and tape it to the front of

the dash panel as show in Figure 25.

The template will be used as a guide

for drilling holes to locate the Six-Gun/

EconoMind and Brake selector switch.
For 2005-07: If installing both Six-Gun/

EconoMind and Brake, trim the back

side of the dash panel as shown in

Figure 26.

Section 3

INSTALLATION OF THE SIx-GUN/ECONOMIND/BRAKE SELECTOR

SWITCHES

Figure 23: Removal of the stereo (03-04 model year vehicles only)

Advertising