Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_Optional Banks Brake & Speed-Loader '03-07 For use with Six-Gun_EconoMind Selector Switch User Manual
Page 24
24
96808 v.14 .0
Figure 22 Brake Module Mounting Location
23.
connect the Banks Brake module
10-pin connector on the Banks Brake
wire harness to the Banks Brake
module. The connector will be the only
one with a label.
NoTE: Make sure the correct connection
is made to the Tuner and the Banks
Brake module before proceeding.
24.
Remove the adhesive backing
from the dual-lock fasteners on the
back of the Brake Module and attach
the module to the location shown in
Figure 22. Apply light pressure to the
Brake Module by hand for 60-seconds
to create a strong bond between the
steering column surface and hook &
loop interlocking fasteners. Using the
supplied cable ties, secure the Banks
Brake module wire harness away from
any moving components.
NoTE: Make sure all mounting surfaces
are entirely clean and free of dirt and
oil before mounting the Brake module.
Clean and dry as required using a cloth
damped in rubbing alcohol or similar
cleaning solution.
25.
Install the top steering column
panel back in place.
26.
Reinstall the plastic key guide into
place. Make sure it is snapped into
place.
27.
Reinstall the three (3) factory
screws to fasten the steering column
plans back together.
28
. The RJ12 connector (phone like
connector) on the Banks Brake Wire
harness will be connected in the next
section to the Brake level selector
switch. Leave this wire loose for
connecting to Brake level switch.
29.
Go over all connection. Secure
the wire harness with the supplied ties
under the dash.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
-END, SEcTION 2-